I just wanted to share a few key settings that I’ve found produce very nice results when printing PetG on my Lulzbot mini… I’m sure most of these settings will work just fine on other printers too. If you would like to know what other settings I’m using just ask! If you want to see some results just look for jkingmedia on instagram and I’ve posted pics of my prints there.Software: Simplify 3DPrinting Temp: 255C Extruder 80C Bed (layers bond very well)Printing Speed: 55mm/sec (I’ve printed up to 90mm/sec with great results too but lost some fine detail)Layer height: 150 microns (I do not recommend any lower, 300 microns also produces great results but with less fine detail)Retraction distance: 1.20mm (This is very important to prevent stringing and blobs)Retraction speed: 40mm/sec (This is very important to prevent stringing and blobs) http://ift.tt/2g704L0