MK2Finally completed building Prusa i3 MK2 after many hours. Several m3 nuts were very hard to fit. Maybe I’m not strong enough. I finally used a hammer to lightly tap them in when needed.I placed the z-axis bottom holders in opposite spots. So I needed to take out z-motors to change.LCD cables weren’t seated properly so when I turned it on the first time I saw the pinda probe light and green light rambo box but nothing else.After reseating lcd cables, I ran self test which failed on z endstop. I reran self test and it failed on z endstop. I then started to make a video to send in to support and the 3rd time it passed everywhere.Then I ran Auto home and the pinda probe is about 1 cm from where it should be on x axis. They are looking into this.I adjusted z-axis up so it hits top so it’s even but z-axis didn’t move at all when I did that.Not sure what I’m doing wrong but I have emailed their support so hopefully will get it worked out. http://ift.tt/20KF2Ta