Printrbot Simple Metal only works with Cura 15.04 which I get the feeling is outdated. On top of that, when I select “support everywhere” several of my prints still fail because they didn’t have support that was really obviously needed.For example, printing the “pass the butter” robot from Rick and Morty, and it fails when printing the center column that supports the robot from its base. This wouldn’t fail if it had proper support, but Cura doesn’t generate proper support.Should I change slicers? I chose Cura because I use it at work a little so I was familiar with it, but I’ve been told Slic3r is also good.Or is it my printing expertise? Am I just not dialing in my prints properly?I apologize ahead of time for lacking any important info, and I very much appreciate your time. Thanks, reddit! http://ift.tt/2dBNqCI