So I got octopi set up on a raspberry pi 3, got it working by itself. Got it tied into s3d so I can export gcode directly out.And then I got a little logitech c270 to hook up to it. At first it was plug and play, and worked great. But the webcam makes the whole setup incredibly inconsistent. Octopi/print will be fine until I go to the control tab and see the webcam. The feed will work for a few minutes, and then it will slow down and freeze, along with the rpi. The only way I can get back into octoprint is to restart the rpi. I’m using all of the defaults set in octopi. Any thoughts? http://ift.tt/2cfL6AI