By the end of the month I’ll most likely get another 3D printer and thus time I’m going bigger and I’ve narrowed it down to two options. Either the Folgertech FT-5 or the Makerfarm Pegasus 12″. Here’s the pros and cons I’ve come uo with between the two.FT-5 (Cost: $499)Pros● Has a bigger Z axis of about 51mm ● Costs $151 dollars less ● Larger community than Makerfarm Pegasus (as of right now I cannot seem to find a Pegasus Facebook group) ● Can print at high speeds ● Can print accuratelyCons● (I haven’t ever bought from Folgertech before, I’m going off of what others say) Instructions are confusing ● Can be a hassle to wireMakerfarm Pegasus 12″ (Cost: $645)Pros● Sells E3D Titan and E3D V6 along with Printer for less than what you’d pay for at competitors (Titan plus E3D V6 combo is $77 dollars if I remember) ● More easier instructions from what I’ve heard ● Rock solid constructionCons● Community lacking (again can’t seem to find a Makerfarm Pegasus Facebook group. I mean if Robo3D can have one why can’t the Pegasus have one?) ● Costs for than FT-5 ● Not a whole lot of mods out there for the Pegasus in comparison to the FT-5In all as of right now I am leaning towards an FT-5 because I am within budget of the printer and I’ll also slap a Titan and Volcano on it as well (also side question how does the Volcano fair out with flexible filaments because I have a roll of Ninjaflex that still needs printing) but I’m open to changing my mind. All comments and input welcome. http://ift.tt/2cdcClI