Hey all, Just wondering I could get some advice on slicing a model-I have this component of a prototype, but am having issues with support material – the cut-out in the front needs supporting seen here, cross-section here – but I can’t simply apply support to the whole model, because the casing has two layers, and so with support the inside layer gets all clogged up with support material that would be impossible to clean – see the green parts here, cross section here.Do you have any suggestions on how to get this piece to print with proper support without ruining the detail structure on the inside/back? I need to be careful since it’s looking to be a 14-16 hour print. Thanks!FYI, I’m using Slic3r on a Flashforge CP. PLA. http://ift.tt/2bmNkRW