Hey, /r/3dprinting – I made something!A few days ago, I was experimenting with making a snap-fit connector in TinkerCad, and I decided to try adapting a cantilever snap-fit to a rotatable joint. I printed a single joint as an experiment, and I was so pleased with the results that I cobbled together a few of them into this posable figure. I wasn’t very optimistic about the results – really, I have almost no artistic ability, and I’d have bet safe money on the proportions being grotesquely skewed – but when I put it together, it struck me as kind of cute.So, here it is: http://ift.tt/2bghdR5 http://ift.tt/2b5n67k