(I guess I should say I printed a pokeball planter) 3DS XL for scale. The print is four parts, all PLA, top (red), middle ring (black), base (white), button (white). I didn’t have regular white so I used a “pearl white” filament that is mildly translucent. With dirt inside you can’t really tell. I recommend printing with 100% infill because it doesn’t take that much more time and the outer layers come out nicer.This is printed at 80% size of the original at 0.1mm layers. The parts are mildly challenging to get together. When I print this again I will print the black ring at 79% and the other parts at 80% and superglue them so I don’t have to hammer them into each other like I had to with this one.Pokeplanter Thingiverse link3DSXL ergonomic grip link in case you’re interestedMy next project is this beast. Wish me luck :)​https://ift.tt/2CuwrSY https://ift.tt/2C0qsnL