Hello, I’m an intern who was tasked with working on a Makerbot 2X 3D printer. I own my own Duplicator i3 and I’ve had great luck with that. I flashed the sailfish firmware and ran a few prints on the printer which turned out acceptable, but now it won’t start up and it says the HBP is at 255C. When I try to run a print it continues to try and cool the build plate and won’t initiate the print. I’ve tried disconnecting the build plate to no avail. I’ve also flashed the regular makerbot firmware and have gotten nowhere. Can anyone help me? Where can I go from here? http://ift.tt/2atqiXK