So I have this issue where after I select home all the bed is so low that even extending the springs all the way loose on the left side it is still to high in the center. On top of this it is unlevel and higher on the right hand side of the bed which caused the nozzle to hit over there.At first I manually turned the black pieces on the rods to compensate for this and it worked but now when I print the extruder is too high and I don’t know what to do.I have googled this alot but am not sure where parts like the x stop, z stop are located on this thing, or even what I was doing before. Any help would be appreciated, keep in mind I am very new to this so any websites that can lay out to me what and where the parts on this thing are would be awesome!Also, Is there any way to change where home all goes manually without rewiring stuff? http://ift.tt/29Pbe6t