So I have seen many people complain about the supports generated by the newer versions of Cura are difficult to remove and too thick compared to the supports generated by the older Cura versions. I was messing around with settings and I found reducing Support Line Width by about 1/4-1/3 of your normal line width results in nicely formed but easily removed supports (this was done in about 10 seconds without tools) that are very similar to the ones that older Cura generated. I did a search for the setting name and didn’t find anything so wasn’t sure if this was well known and I’m just behind the times or what but figured I’d share.Edit: I should add that the setting is hidden by default and has to be enabled in the settings. http://ift.tt/2quwKXZ