https://ift.tt/3cxPY2B https://ift.tt/3drHs6p
2nd time make my own model! Went from Tinker cad to fusion 360, and it is SO much more accurate.
Month: June 2020
I modeled and printed all of Canadian Space Agency’s satellites
https://ift.tt/3eFzNBv https://ift.tt/2BmckqF
Pretty st0ked, yall. Just published my first “thing”
https://ift.tt/2BoRyH4 https://ift.tt/3cnYgKd
Yet another RPi 4 case. I spent countless hours on Fusion 360 designing it. Came put really nice, except for the RPi logo cut out. I may need to play around with the design a bit more. What are your thoughts?
https://ift.tt/36THHo5 https://ift.tt/2zJv57f
My new Cleric mini!
https://ift.tt/2XlOioq https://ift.tt/2zJijpj
I’m working on an automatic plant watering system. Instead of using one pump per plant, I’m trying to build a remotely controllable “water turret”.
https://ift.tt/3cswImS https://ift.tt/3clCTsR
Magical silk rainbow filament tree
https://ift.tt/3crvh8a https://ift.tt/2XTqwPp
Made this little light up comic book stand
https://ift.tt/2MlqPNG https://ift.tt/3gTlbAC
Hyundai were asking $940 to replace the trunk switch in my car after the rubber cover perished (apparently it is hardwired into the reverse camera wire loom). I cut the wire on the old one, modelled up a replacement and spent $1.50 on a new switch. Duct tape for the cover, and it’s good to go.
https://ift.tt/2Xlab7i https://ift.tt/2zQH8zt
Bike suspension data acquisition
https://ift.tt/2ZWZ8mp https://ift.tt/2BoxCEb