https://ift.tt/2EPvVPf https://ift.tt/2VBICTn
Two weeks after finishing my Mk3S, I designed and built a new control panel for an old 1940’s drill press.
Month: March 2019
As my first print to ever be born into the world, I finally understand this “first layer porn” satisfaction (Flexi rexi)
https://ift.tt/2XCa7yd https://ift.tt/2SMFMJj
Designed a ruler that makes dotted lines for my engineering classes
https://ift.tt/2HhD2lc https://ift.tt/2TvG5gd
Finished print of Jukka Seppänen’s Nine-Tailed Demon Fox
https://ift.tt/2H2gbL8 https://ift.tt/2NJaiTG
Just finished printing out Printable Sceneries Sorcerers tower! Next up is the Library of Ithillia. These have been some of the most fun prints I’ve done.
https://ift.tt/2C94ZZg https://ift.tt/2UihJ6U
Local Hackerspace hosted a smash brothers tournament and gave out these trophies.
https://ift.tt/2TCkCCw https://ift.tt/2J3EKsO
Printed a little Link (more in comments)
https://ift.tt/2TtmRIe https://ift.tt/2IS53SN
Latest edition
https://ift.tt/2Tz43qT https://ift.tt/2ITMOfU
Sanded from 120-400. First bit of filler primer now. May sand again, not sure … printed on ender 3
https://ift.tt/2TuySx2 https://ift.tt/2ISKVQD
Electronics board for my new printer
https://ift.tt/2UoQyHu https://ift.tt/2C2pM0o