Month: February 2019

Modified Prusa MK3 LACK enclosure

EDIT: Thank you very much for the gold!I finally finished LACK enclosure for my Prusa MK3.​Finished enclosureI more or less followed the instructions at http://bit.ly/2G6AN4C, but I modified the STL files a bit:I made a slot for the thermometer in the front left leg, so no ugly electronics sitting on top or cables running through plexiglass.A thermometer inserted into the corner piece.I made a slot for LED dimmer in the front right leg corner piece, so I can adjust the lights or turn them off. Electronics extracted from this dimmer.A dimmer inside the corner pieceFinally, I changed the door knobs so the magnet is inserted inside a slot. This protects the magnet from shattering, separates the magnets, so less force is needed to open the doors and does not require any glue to hold the magnet in place.Door piece with magnet slots. Similar slots are used on the other pieces.EDIT: After a few requests I am sharing the files: http://bit.ly/2WDbagD http://bit.ly/2RzKI3V