http://bit.ly/2ImOGNN http://bit.ly/2IlYXtQ
Another tailed “beast” printed with thermochromic filament.
Month: February 2019
I made a lithophane lamp as wedding gift for my daughter.
http://bit.ly/2V0eYH2 http://bit.ly/2tANE6V
Finally enclosed my printer, what a difference in heat up time and quality.
http://bit.ly/2S82wTP http://bit.ly/2ton4xE
Neat 3d printed hamster hideout
http://bit.ly/2V2qwcU http://bit.ly/2Xj16Ke
First pieces of an Epic Chess Set I’m making. Spiral Chess set by JaaYoo on Thingiverse
http://bit.ly/2BCJxvi http://bit.ly/2U15tHT
Parents tumble dryer lost door hook so I designed and printed a new one.
http://bit.ly/2GuoSO9 http://bit.ly/2IvsCk2
Homemade Resin Printer
http://bit.ly/2GLAsUq http://bit.ly/2ttauNr
Curiosity on Prusa MK3
http://bit.ly/2IkHQsm http://bit.ly/2EgxQft
So I tried Cura’s Fuzzy Skin mode. Yeah….it’s like they took every problem we’ve tried to tune out and put them all together….and called it a mode. I could see where it might have its uses though.
http://bit.ly/2U0nUMR http://bit.ly/2BFZReO
A 74 hour print just finished. I took off all the support. Dr. Pepper for scale. It is from Thingy-place. Eric’s Chevy engine.
http://bit.ly/2TVs1JR http://bit.ly/2BFZPUe