December 2018 – Page 14 – 3d Printer reviews and information

Commander Cody, ready for painting!

http://bit.ly/2RdRDUa http://bit.ly/2GBilBX

yippee ki yay! just a little lithophane ornament.

http://bit.ly/2RdRDDE http://bit.ly/2Gzkuht

This is what we need

http://bit.ly/2EKqulZ http://bit.ly/2ShlLvg

Do yourself a favor and play with a .2mm nozzle.

http://bit.ly/2ShSQqG http://bit.ly/2Ac9n8K

Banzai Bill printed at 250% scale. Hopefully I’m not to late to the Banzai Bill party. Printed on an Ender 3 at .15 mm layer height.

http://bit.ly/2CucURc http://bit.ly/2T4esHe

Setting an M3 nut into a mount for my trigorilla mosfet using the soldering iron as my printer made the holes a tad too small

http://bit.ly/2GEPFrR http://bit.ly/2Rkzvbv

I’ve been using sandpaper to clean support surfaces until I found these rotary discs. Works quite a bit better imo.

http://bit.ly/2PYmGi0 http://bit.ly/2V8tfCm

I printed some Baby Groots! Here’s before and after painting it :) (printer is MP Mini Pro)

http://bit.ly/2PXStj4 http://bit.ly/2V8I2xh

Just made a fancy Smash Bros Lithopane! (Op in comments)

http://bit.ly/2PXSyTU http://bit.ly/2V4aEYa

Any snek hat is possible with 3d printing

http://bit.ly/2AfMJfA http://bit.ly/2Smzq4l