https://ift.tt/2OY0m7G https://ift.tt/2zlnCI0
My first dual extruder non-calibration print. Still needs tuning but I still like it.
Month: November 2018
Designed a Supercapacitor Powered Car
https://ift.tt/2R5mfUu https://ift.tt/2PLkDCJ
Zerg Hydralisk, 28mm, first mini model
https://ift.tt/2QbkkRb https://ift.tt/2DzQE9w
My first commission from a local pottery artist. A signature stamp. A little larger than a half dollar.
https://ift.tt/2QahrQC https://ift.tt/2DEDkRA
Zombie Hand Watch Stand
https://ift.tt/2znpQGV https://ift.tt/2ORkoRr
Hail Hydra!
https://ift.tt/2FzBiEF https://ift.tt/2qZvaeL
Been holding up in the snow! (They are on post outside my house)
https://ift.tt/2DQNqj8 https://ift.tt/2S9EKHL
My first benchy
https://ift.tt/2DRCodu https://ift.tt/2S9EIQ9
Made an air filter for my 3d printer. Uses an arduino to control the fan speed based on temperature keeping the printing space at 85 degrees F. Air goes through two carbon filters and a HEPA filter. Will eventually add another duct on the other end to continuously circulate the air
https://ift.tt/2QbeYVT https://ift.tt/2DAWojq
My first test print with soluble interface layers (dual extrusion). 3D printing just got so much more fun for me!
https://ift.tt/2QbeYFn https://ift.tt/2DAWnvS