https://ift.tt/2N3UlFZ https://ift.tt/2KNHR91
Printed the Brabeast and planetary gear adaptor for a gift
Month: July 2018
Looking good w/no supports.
https://ift.tt/2u8hOii https://ift.tt/2zmEQXM
Watney is AWD, turns like a tank, and can pivot its wide-angle camera up and down. Its hardware and software is fully open-source
https://ift.tt/2zxMMFY https://ift.tt/2m5qy4l
Ono3D/Olo3d is trying to crowdfund again despite they are yet to fullfill their kickstarter campaign from almost 2 years ago
https://ift.tt/2NGuu8b https://ift.tt/2NDSXLq
I can already tell that this will be one of my favorite prints I’ve done. The detail on it is crazy.
https://ift.tt/2um0829 https://ift.tt/2u8kzQV
Cool! Someone printed it for over 80 hours.
https://ift.tt/2L4af2G https://ift.tt/2NF1BcM
Almost made it to the 24 hour club with my 2nd print ever.
https://ift.tt/2NDMVdG https://ift.tt/2L0U4mD
Its highly 3D-Printed!
https://ift.tt/2zpdlgg https://ift.tt/2u5ZTsq
One of my favorite and most challenging prints. This polar bear has a permanent spot on top of my PC.
https://ift.tt/2N3mQDW https://ift.tt/2KHVfeA
Lower arm done. Added some LEDs to the helmet. Left hand being printed right now.
https://ift.tt/2N1zraw https://ift.tt/2KIzPOx