https://ift.tt/2Eft6n4 https://ift.tt/2GQiL6z
Slicer comparison (Cura, KISSlicer, and Slic3r). The same model, the same spool of PLA, all printed within 24 hours of each other.
Month: April 2018
To this day, the power of the CR-10 amazes me. Complete and working model of a gas turbine engine!
https://ift.tt/2pZz5re https://ift.tt/2Jdv4It
My first original project with my new(ish) 3 printer was to design and print a Raspberry Pi case that clips to the side of an Ikea Lack end table. Really empowering to design something in on a computer and hold it in your hands a few hours later.
https://ift.tt/2InSU2T https://ift.tt/2H4MTJ7
I just felt like being crazy I guess
https://ift.tt/2GtdcaM https://ift.tt/2GtaDt8
Water Stone Vase (Fifth Element)
https://ift.tt/2Gp7DOu https://ift.tt/2pZZyoC
My Interview with Tom about the Backpack 3D printer.
https://youtu.be/2lsx_rCCsQI https://ift.tt/2pYNeVC
Extruder motor is skipping. Im not sure why.
https://ift.tt/2uF3QHD https://ift.tt/2pYMHDU
I made a wire holder for pegboards
https://ift.tt/2GxNWQQ https://ift.tt/2pY9Shx
My first Benchie
https://ift.tt/2GuLYEM https://ift.tt/2GtQ1x7
Some of you asked for more pics of this FDM quadcopter, so here’s an album.
FDM quadcopter print test on a Taz 6 – I bit the bullet and made a picture album since you all were interested in my lazy one pic post. https://ift.tt/2GsAVMn https://ift.tt/2EaT8rK