Month: September 2017

http://ift.tt/2gUQy3e http://ift.tt/2vOfsEf

http://ift.tt/2jfcJSe http://ift.tt/2eZaNMl

http://ift.tt/2jgvipa http://ift.tt/2eXsHiQ

http://ift.tt/2xeVplG http://ift.tt/2ePa24S

http://ift.tt/2wSW9MR http://ift.tt/2wiOWC8

http://ift.tt/2vXunzY http://ift.tt/2gVd2gJ

http://ift.tt/2xosexw http://ift.tt/2gUnAwu

http://ift.tt/2xokITs http://ift.tt/2gUnuVE

I designed and made a part unloader for my Ultimaker 2. The design is on thingiverse With this setup you can print multiple smaller parts one at a time. The unloading is started by a gcode that sends the extruder to a corner. You can place and remove the part unloader in a few seconds. http://ift.tt/2vYlENO

http://ift.tt/2xezKKs http://ift.tt/2eO1GdP