I’ve gotten the auto level setup on my printer. Running Marlin firmware. Auto level gives these results: 0 1 2 3 4 0 -0.05 -0.02 -0.02 +0.01 +0.36 1 +0.01 +0.02 +0.01 +0.01 +0.31 2 +0.04 +0.06 +0.03 +0.02 +0.32 3 +0.10 +0.08 +0.03 +0.03 +0.29 4. +0.19 +0.16 +0.07 +0.04 +0.29My printer is set up so X0Y0 is in the lower left corner as I view it. The auto level begins near X0Y0 and probes from left to right, bottom to the top; ending near X200Y200.Does the first point probed (near X0Y0) correspond to Row0-Column0 of the auto level results? Or would it be Row4-Column0.The printer is getting good results at the center of the print bed. I would like to print some larger prints, but the right side numbers are a little worrying. I am worried about jacking up what seems like a good bed leveling. http://ift.tt/2sjxn7o
