Made some tiny g clamps on the form2 at work. That knurling! http://ift.tt/2eI8fwJ http://ift.tt/2e9QxX1
A diagram answering about 95% of all the “which printer should I buy” posts. http://ift.tt/2fkqXvv http://ift.tt/2fDvfCb
Hatchbox PLA or setup issues? These lines don’t happen with Monoprice PLA. http://ift.tt/2fD8C0A http://ift.tt/2fkdBj9
I totally just grabbed my hot end with bare fingers 200C hurts pretty bad for about an hour. After that the skin is just dead, almost like a callus, and feels fine. Fun! Try it!(don’t try it) http://ift.tt/2eGF1OJ
Couldn’t find a replacement part for my 1985 car, so 3D modeled it and printed a new one! http://ift.tt/2fB6PZM http://ift.tt/2fi83Wi
3D printed fixed gear for a friend. Needs cleaning up, but other C&C welcome. http://ift.tt/2fB062d http://ift.tt/2e81g3V