Author: 3dprinterbank

http://ift.tt/28U6UFi http://ift.tt/28Pag8K

https://www.youtube.com/watch?v=HVbsmDrPYo0 http://ift.tt/28QeLxH

Has anyone had printing experience with Micro’s ABS-R? We need the strength properties of ABS, but as you know the warp is an issue, and the fumes kill me. (I have put in a full exhaust system for my printing setup.) I’ve been looking at using it as alternative, but wanted to hear honest reviews first. Thanks!Link: http://ift.tt/21lANNc http://ift.tt/290QS8s

I’ve had several ideas recently about printing somethings that would be used around stuff that will end up in your mouth. I’m wondering to what extent I can safely get away with.Things like cookie cutters or toothbrush holders/cases. not things like forks or cups.If those things are no good, is there some other post process that i can do to make it safe?I print PLA on a Da Vinci Jr. http://ift.tt/290QNBN

http://ift.tt/28RANlD http://ift.tt/290H3HJ

http://ift.tt/28PznGF http://ift.tt/290H922

http://ift.tt/28T2Tk3 http://ift.tt/28QXM0C

While upgrading my Wanhao i3 to a swiss MK10, it seems as though I may have stripped the block set screw. Anyone know the dimensions of this part? I haven’t been able to find the specs anywhere. http://ift.tt/28PNr5X

https://www.youtube.com/watch?v=thvb3t-KO00 http://ift.tt/28ZJlGR

I’m looking to build an enclosure for my machine, but I’ve heard mixed results in regards to where to put the filament spoolObviously inside the enclosure seems more practical, but some folks say repeatedly heating the filament inside the enclosure is bad.Does this only apply to PLA and other materials with low GT temps? Is it safe to do this with ABS filament, for example? I’d prefer not to mount the spools outside. http://ift.tt/28SJjnJ